|
Magnetic
Sensors
|
|
Canvas Sensor
|
For protection of
canvas covers. The CS1 is a direct replacement for existing canvas snaps.
The switch is weatherproof, normal closed and is easy to install. Switch is
made of brass and stainless steel.
Canvas Sensor - Part # CS1 |
|
|
Push Button Sensor
 |
The MG5 flush mounts in doorways
and hatches where a completely concealed sensor is desired. The flanged push
button switch is normally closed and comes with 12" of wire. Switch
diameter is .75"
Flanged Push Button Sensor-
Part # MG5 |
|
|
Mini Wide Gap
Sensor
|
The MG10 protects
entrance hatches, and other areas where a small surface mount magnetic
switch is desired. The switch is normally closed and has a 1.0" gap.
The switch is 1.25" X .375" X .375" and has 6 ft. of wire.
Mini Wide Gap Sensor - Part # MG10 |
|
|
Flush Mount Sensor
|
The MG15 flush
mounts in doorways, hatches and stereo compartments, where a completely
concealed sensor is desired. The cylinder shaped switch is normally closed
and comes with 12" of wire. Switch diameter is .25".
Flush Mount Sensor - Part # MG15 |
|
|
Engine Hatch Sensor
|
Secures large
engine and storage compartments. Reduces installation time while providing
a factory finish. Switch gap is 2.5". Switch is pre-wired with 20 feet
of shielded wire and comes with a complete selection of stainless mounting
hardware. Switch dimensions -
2.0" X .50" X .50".
Engine Hatch Sensor - Part # MG20 |
|
|
Instrument Sensor
|
The MG1005 secures
radar sets, depth finders and equipment that is easily removed. When sensor
is removed the normally closed contacts open.
Instrument Sensor - Part # MG1005 |
